NATURAL STONE SYSTEMS

Description Short

Depending on the model, the HALFEN Body anchor carries both vertical loads from the panel weight and horizontal loads, for example, from the wind. Depending on the building situation, you can choose from four different models of HALFEN Body anchor.

More product information click here

HALFEN BA Body anchors

HALFEN BA Body anchors are designed for small stand-off distances from 60 to 120mm with a maximum load of 1300N. The anchors consist of a sturdy base element, a serrated plate and a spade bolt. The BA Body anchor is fixed according to the installation instructions, either in the horizontal or vertical panel joint, to load-bearing substrate to HALFEN Cast-in channels or using HALFEN Anchor bolt systems. The bracket has a vertical 8.5 × 28mm slot and a serrated plate for easy height-adjustment. As with all body anchors the distance to the load-bearing substrate is adjusted by turning the spade bolt. The anchor bracket can of course be adjusted laterally by swivelling around the fixing bolt.

HALFEN DT Body anchors

HALFEN DT Body anchors (structural anchors) are suitable for large stand-off distances of 140 to 300mm and loads of up to 1300N. The pre-assembled anchors consist of the main bracket, the adjustable wedge plate and a spade bolt. Vertical bracket adjustment is made using the sliding wedge plate. The stand-off distance to the supporting substrate can be adjusted using the spade bolt. The Body anchor DT can also be pivoted around the fixing bolt for lateral adjustment. The spade bolt is pre-assembled to use in the horizon panel, but is easily adjusted for use in the vertical joints by rotating the spade bolt. The clamping bolt must be tightened with a spanner following the installation of the natural stone panel to a torque of 5 Nm.

HALFEN DH Body restraint anchors

HALFEN DH Body restraint anchors are adjustable in three dimensions. They are designed to carry only horizontal tension or compression loads. DH Body anchors are used in combination with HALFEN HRM/HRC, BA and DT Body anchors. The restraint anchor is used mainly in vertical joints, for edges and corners including parapet slabs. They are designed for stand-off installations of 60 to 320 mm with a maximum horizontal load of 1300N. Stand-off distance from the main structure is adjusted using the spade bolt.
A 9 × 30mm slot allows vertical adjustment. The anchor is pivoted for lateral adjustment. The anchor is supplied with a spade bolt, which is secured to the body with a locking nut.